Mounting SUPERSTRIPS®  

  Step 1  
Peel adhesive liner and attach first SUPERSTRIP along bottom edge of the Display Area
(Tip: mark bottom edge with a pencil first)

  Step 2  
Cut 3 SPACERS 1/8-inch (3mm) taller than prints to be mounted
Insert SPACERS 1/8-inch (3mm) into slot (to adhesive backing) 

  Step 3  
Attach second SUPERSTRIP using SPACERS as a guide
(Tip: peel liner back in short sections and tack lightly at SPACERS first)

  Step 4  
Repeat Steps 2 & 3 to add more SUPERSTRIPS®

 

  Mounting Photographs  

Step 1 - Position

Step 2 - Secure

Step 3 - Release

To position print, push top edge into upper slot (1) and slide left or right (2)

To secure print, push bottom edge 1/8-inch (3 mm) into lower slot (3)

To release print, reverse (3) or pull top edge out of upper slot and pull out (4)

Additional Tips

SUPERSTRIPS® Order Form Wholesale Distributor Home

 
Wall-Album®, SUPERSTRIPS™, PlayMaker®, Bathbar® & Washbar® are trademarks of Biospace Corporation.
Biospace® is a registered trademark of Biospace International AG. © Biospace Corporation.
All rights reserved. U.S. and International Patents apply or are pending.

Best viewed with Microsoft® Internet Explorer 4 or greater.
Kindly report any problems with this page to Webmaster.